MyPoolSigns: Thank you for your order. We appreciate your feedback. When applying the tags please see instructions below to do so.
Clean an area that is 6 to 8 inches larger than the graphic, using a solution of 20 drops of detergent per pint (400 ml) of water. Do not use soaps or enzyme detergents. Wipe the area clean and then dry it with a lint-free paper towel. Be sure to remove all soil and grit. Remove any oil or grease by wiping the floor with a clean, lint-free paper towel that has been moistened with rubbing alcohol that contains no lotions. To avoid leaving a residue, wipe the surface completely dry with a lint-free paper towel before the alcohol evaporates. Position the graphic. Avoid aligning the edges of the graphic on grout lines of tile. Do not smooth the graphics with your hands because this entraps air. Peel back one half of the liner to expose the adhesive. Carefully cut off that part of the liner while holding the graphic away from the surface. Make one stroke across the center of the graphic. Continue stroking edge-to-edge across the shortest distance until that half of the graphic is applied. Lift the other end of the graphics and remove the remaining liner. Continue stroking edge-to-edge across the shortest distance until that half of the graphic is applied.